Inserting a scene from a VCR - Insert editing
To change the insert end point
Press ZERO SET MEMORY again af'.er step 5 to erase the ZERO SET MEMORY
indicator and begin fl'om step 3.
Using the Remote Commander
(DCR-TRV1 I/TRV20 only)
In step 5, press @REC and MARK simultaneously, then immediately press n. And in
step 6, press II at the scene where you want to start recording from.
Note
The picture alld sound recorded Oil tile portion betvveen the insert start and end points
will be erased when you insert tile new scene.
If you insert scenes on the tape recorded with other camcorder (including other
DCR-TRV6/TRV11/TRV20)
Tim picture and sound n-lay be distorted. We reeonnnend tbat you insert scenes on a
tape recorded with your camcorder.
When the inserted picture is played back
The picture and sound may be distorted at the end of the inserted portion. This is not a
malfunction.
The picture and sound at the start point and tile end point may be distorted in tile LP
mode.
To insert a scene without setting the insert end point
Skip steps 3 and 4. Press • when you want to stop inserting.
72
To Next Page
Loading...
