Audio dubbing
Notes
• New sound cannot be recorded on a tape already recorded in the 16 bit mode (32 kHz,
44.1 kHz or 48kHz) (p. 89).
• New sound cannot be recoMed on a tape already recorded in the LP mode.
• You cannot add audio with the _,DV IN/OUT jack.
Ifyou make all the connections
The audio input to be recorded will take precedence over others in tile fbllowing order.
• MIC (PLUG IN POWER) jack
• Intelligent accesso W shoe
• AUDIO/VIDEO jack
• Built in microphone
If an i.LINK cable (DV connecting cable) (not supplied) is connected to your
camcorder
You cannot add a sound to a recorded tape.
To add new sound more precisely
Press ZERO SET MEMORY on the Remote Commander at the point where you want to
stop recording later in the playback mode.
Can T out steps 3to 5.Recording automatically stops at the point where ZERO SET
MEMORY was pressed.
We recommend that you add new sound on a tape recorded with your camcorder
If'you add new sound on a tape recorded with another camcorder (including
DCR TRV6/TRV11/TRV20), the sound quality may become worse.
If you set the write-protect tab of the tape to lock
You cannot record on a tape. Slide the write protect tab to release the write protection.
On blank portions
You cannot add an audio.
76
To Next Page
Loading...
