Using the fader function
(1) When fading in [a]
In standhy mode, press FADER until tile desired fader indicator flashes.
When fadin 9 out [b]
In recording mode, press FADER until tile desired fader indicator flashes.
Tile indicator changes as follows:
FADER --+ MONOTONE --+ OVERLAP --+WIPE --+DOT--+ no indicator
Tile last selected fader mode is indicated first.
(2) Press START/STOP. After tile fade in/out is carried out, your camcorder
automatically returns to tile normal mode.
FADER 1 _l_
FADER
To cancel the fader function
Press FADER until the indicator disappears.
Note
You cannot use the following functions while using the fader function, and vice versa:
Digital effect
Low lux mode of PROGRAM AE (Only in OVERLAP, WIPE, or DOT mode)
Tape Photo recording
Interval recording
Cut recording
When the OVERLAP, WIPE, or DOT indicator appears
Your camcorder automatically stores the image recorded on a tape. As the image is
being stored, the fader indicator flashes fast, and the playback picture appears.
38
To Next Page
Loading...
