78
Troubleshooting (Continued)
The battery pack discharges too quickly.
• Ambient temperature is too high or low, or the battery pack has not been charged enough.
This is not a malfunction.
• Fully charge the battery again. If the problem persists, the battery may be worn-out. Replace
it with a new one (
p. 12, 91).
The picture remains on the LCD screen.
• This occurs if you disconnect the DC plug or remove the battery pack without turning off the
power first. This is not a malfunction.
The picture in the viewfinder is not clear.
• Move the viewfinder lens adjustment lever until the picture appears clearly (p. 16).
The picture in the viewfinder has disappeared.
• If you change [VF POWERMODE] to [AUTO], the finder light remains off while the LCD
panel is open (
p. 65).
The supplied Remote Commander does not function.
• Set [REMOTE CTRL] to [ON] (p. 70).
• Remove any obstructions between the Remote Commander and the remote sensor.
• Keep strong light sources, such as sunlight or overhead lighting, away from the remote
sensor, otherwise the Remote Commander may not function properly.
• Insert a fresh battery in the compartment with its +/– terminals matching those of the
compartment (
p. 105).
Another VCR malfunctions when you use the supplied Remote Commander.
• Select a commander mode other than VTR 2 for your VCR.
• Cover the sensor of your VCR with black paper.
The cassette cannot be ejected from the compartment.
• Make sure the power source (battery pack or AC Adaptor) is connected correctly (p. 12).
• Moisture condensation has occurred inside the camcorder (p. 94).
The Cassette Memory indicator or title display does not appear while using a
cassette with the Cassette Memory function.
• This camcorder does not support the Cassette Memory function, so the indicator does not
appear.
The remaining tape indicator is not displayed.
•Set [ REMAINING] to [ON] to always display the remaining tape indicator (p. 66).
Cassette tapes/“Memory Stick Duo” media
To Next Page
Loading...
