RadarW
Adjust the color separation matrix coefficient so that proper color
reproduction is produced.
Mode CAMERA
Subject Color bar chart
(Standard picture frame with the
zoom lens at WIDE end)
Measurement Point Video terminal of A/V OUT jack
(75 Ω terminated)
Measuring Instrument Vectorscope
Adjustment Page F
Adjustment Address A4 to AF
Specified Value All color luminance points
should settle within each color
reproduction frame.
Menu setting:
1) VIDEO OUT of SET UP menu
................................ NTSC (NTSC mode)
Note 1: “Auto White Balance 3200K Standard Data Input” and
“Auto White Balance 5800K Standard Data Input” need
to be adjusted beforehand.
Note 2: Check that the data of page: 6, address: 02 is “00”.
If not, turn the power of unit OFF/ON.
Note 3: “Color Reproduction Adjustment” is available only once
after the power is turned on. Turn the power off, then on
again if the adjustment is retried.
Adjusting method:
Order Page Address Data Procedure
1
Perform “Data setting during
camera system adjustment”.
(Refer to page 6-14)
2
Perform “Picture Frame
Setting”. (Refer to page 6-15)
3 6 01 AB Press PAUSE button.
4 6 12 80
5 Wait for 1 second.
6 6 12 00
7 Wait for 2 seconds.
86 371F
9 6 01 A9 Press PAUSE button. (Note 4)
10 6 02
Check the data changes to
“01”.
11
Check the each color lumi-
nance point is in each color
reproduction frame.
Note 4: The adjustment data will be automatically input to page:
F, address: A4 to AF.
Processing after Completing Adjustment:
Order Page Address Data Procedure
1 6 37 00
2 6 01 00 Press PAUSE button.
3
Release the data setting
performed at step 1.
(Refer to page 6-14)
Fig. 6-1-16
To Next Page
Loading...
