Your personal computer
does not recognize your
camera.
l
The battery level is low.
+Use the AC power adaptor (page 14)
l
The camera is turned off.
*Turn on the camera.
l
The USB cable is not connected firmly.
*Disconnect the USB cable, and connect it again
firmly. Make sure that “USB MODE” is
displayed on the LCD screen (pages 33,35).
l
The USB connectors on your personal computer are
)
connected to other equipment besides the keyboard,
the mouse, and your camera.
*Disconnect the USB cables except for the ones
connected to the keyboard, the mouse, and your
camera.
l
The USB driver is not installed.
*Install the USB driver (page 33).
l
[USB CONNECT] is set to [IV] in the setup settings.
+Set it to [NORMAL] (page 8 1).
l
Since the camera is connected to a computer with
the USB cable before installing the USB driver, the
drive is not recognized by the computer.
*Delete the drive which is not recognized, then
install the USB driver. For details, see the
+Remove the battery pack, then install it again
after about one minute. If the function still do
not work, press the reset button located on the
bottom using a sharp-pointed object. (If you
press the reset button, the date and time setting
P
92
To Next Page
Loading...
