Location and Function of Parts
10
camera control unit regardless of the PROD/ENG switch
position.
g PROGRAM knob
Adjusts the program audio reception level.
When using a DXC-D50 series camera, setting the MIC/
LEVEL switch i to OFF/FRONT will enable this knob
to adjust the balance between the program audio and
intercom audio levels. Turn clockwise to raise the
program audio level, and turn counterclockwise to raise
the intercom audio level.
h INTERCOM knob
Adjusts the intercom audio reception level.
Setting the MIC/LEVEL switch i to OFF/FRONT will
enable the audio level knob on the DXC-D50 series
camera’s front panel to adjust both the intercom audio
and program audio levels.
Note
If you switch the position of the MIC/LEVEL switch i,
settings of the program audio reception level and
intercom audio reception level are changed. Adjust them
again using the PROGRAM knob g and INTERCOM
knob h.
i MIC/LEVEL switch
Decides the on/off of the intercom microphone and the
adjusting method of the reception level.
ON/REAR: Sets the intercom microphone to on. The
reception level is adjusted using the INTERCOM
knob.
OFF/REAR: Sets the intercom microphone to off.
The reception level is adjusted using the INTERCOM
knob.
OFF/FRONT: Sets the intercom microphone to off.
The reception level is adjusted using the camera’s
front panel.
At this position, while you are pressing the VTR start/
stop button on the camera, the microphone of the
intercom is on.
To Next Page
Loading...
