Sony DXC-D50 - Transferring Scene Files between the Camera and a Memory Stick (with the DXC-D50 Series)

100
File Operations
Transferring Scene Files between
the camera and a Memory Stick
(with the DXC-D50 Series)
When a DXC-D50-series camera is connected, the
registered scene files can be stored as a data block and
can be read when required.
Storing the scene files on a Memory Stick
Proceed as follows:
1 Insert the Memory Stick (see page 105).
2 Press the OTHERS button in the Menu operation
block so that the OTHERS menu is displayed on
the LCD, then press
[RCP Config] to call the RCP
Config menu.
3 Set the menu to Advanced Setting mode.
1)Press
[Security] on the RCP Config menu.
2)Press and highlight
[Engineer Mode].
The
[Status], [Menu Set], and [Code No.]
buttons are displayed.
3)Press
[Status].
The Security Status menu appears.
4)Press
[Advance Mode].
4 Return to the OTHERS menu, and press [File].
5 Press [File Trans].
The Scene File Transfer display appears.
6 Press [CAM -> MS].
A confirmation display appears.
7 Press [Start].
The registered scene files are transferred to the
Memory Stick.
When the transfer is finished
The termination message “COMPLETED” appears.
Reading the scene files from a Memory
Stick
Proceed as follows:
1 Insert the Memory Stick (see page 105).
2 Operate in the same manner as when you stored
the files until the Scene File Transfer display
appears.
3 Press [MS -> CAM].
A confirmation display appears.
4 Press [Start].
The scene files are transferred from the Memory Stick
to the connected camera.
When the transfer is finished
The termination message “COMPLETED” appears.