1. Select [Settings] - [Network Settings] - [Internet Settings].
2. Select [Wireless Setup].
3. Select [Select access point].
The HDD AUDIO PLAYER starts searching for the available access point.
4. When the list of available network names (SSID) is displayed, select [Add a new access
point].
5. Select [(WPS) PIN Method].
The (WPS) PIN code for the HDD AUDIO PLAYER appears.
6. Enter the (WPS) PIN code of HDD AUDIO PLAYER into the wireless LAN router/access
point.
For details on entering the (WPS) PIN code, refer to the operating manual of your wireless
LAN router/access point.
7. When you have finished entering the (WPS) PIN code, select [Start] on the HDD AUDIO
PLAYER.
The HDD AUDIO PLAYER and wireless LAN router/access point start authenticating the
connection with each other.
When the certification is completed, a confirmation screen of the network name (SSID)
and security key (WEP/WPA) appears.
8. Select [Next] on the confirmation screen.
9. When the setup is completed, select [OK] on the screen.
Note
You cannot cancel the connection after the HDD AUDIO PLAYER has started connecting to
the network.
Do not turn the power off while the HDD AUDIO PLAYER is connecting to the network.
[35] Playing music
Playable audio file formats
The following audio file formats can be played on the HDD AUDIO PLAYER.
Note
Only the LPCM 2ch audio format can be played when the signal is input through the
OPTICAL IN or COAXIAL IN jack. (The HDD AUDIO PLAYER supports the LPCM format
To Next Page
Loading...
Need help?
General
Weight and Dimensions
