Sony IT-A100 - Redialing; Using Touch-Tone Services (for Pulse Dialing Systems Only)

You can redial the last number called with just one touch of the
REDIAL/PAUSE button. This lets you easily redial the same number
again if the line was busy.
1
Pick up the handset.
You hear a dial tone.
2
!
Th Press REDIAL/PAUSE.
e
number
must
not
be
longer
St
a
.
.
than 32 digits for pulse dialing The last sequence of digits dialed will be automatically
system and 31 digits for tone redialed.
dialing system (tone and pause
are each counted as one digit);
otherwise you will hear five
short error beeps and the call will
not be connected.
Using touch-tone services (for pulse dialing systems only)
Some services require you to use touch-tone. This is not a problem if
your phone already uses tone dialing. If your phone uses pulse
dialing, however, you need to follow the steps below to use these
services.
1
Use the phone to dial the service number.
!
When connected to the service, press TONE @.
You only need to press TONE
once to turn dialing to tone; this
will remain effective until the call
is disconnected.
3
Press the dialing keys as required.
Using as a telephone | 1