Sony IT-A100 - General; Troubleshooting

Troubleshooting
Problem Solution
Storing memory dialing numbers
You hear five short error ¢ Make sure you follow the procedure in storing the number cor-
beeps and cannot store a rectly (page 16).
memory
dialing
number.
¢
Make
sure
the
number
(including
the
tone
and
pause
digits,
if
used)
is
less
than
16
digits for
pulse
dialing
mode
or
15 digits
for
tone
dialing
mode.
Making a call
You hear no dial tone. ¢ Make sure the telephone line cord is securely connected to the
telephone outlet.
The telephone always ¢ Make sure the dial mode setting is correct (page 12).
connects to the wrong
number, or not connects at
all, even the numbers you
dial are correct.
The
phone
does
not
redial
¢
Make
sure
the
number
(including
the
tone
and
pause
digits,
if
used)
correctly. you last dialed is less than 32 digits for pulse dialing or 31 digits for
tone dialing.
¢ Make sure the last dialed number is really the one you want to dial.
The other person’s voice can ¢ Press the VOLUME + control.
hardly be heard.
Receiving a call
The phone does not ring. © Set the RINGER LEVEL switch to H or L.
The phone does not record ¢ Make sure the answering function is turned on with the standard
incoming messages. mode.
¢ Make sure the tape is not full; if necessary, clear the messages.
¢ Make sure the AC power adaptor and the telephone line cord are
firmly connected.
¢ Try to find out if there was a power interruption.
The phone quits recording ¢ Callers cannot leave messages that are longer than 4 minutes.
before
callers
finish
leaving
¢
Callers
must
speak
loud
enough
when
recording
their
message.
their
messages.
The
line
is
disconnected
if
no
voice
is
heard
for
7
seconds
or
more.
B | General