Sony IT-A100 - Page 3

(2. Unplug this product from the wall outlet and refer servicing to qualified service personnel
under the following conditions.
A. When the power cord or plug is damaged or frayed.
B. If liquid has been spilled into the product.
C. If the product has been exposed to rain or water.
D. If the product does not operate normally by following the operating instructions. Adjust only
those controls that are covered by the operating instructions because improper adjustment of
other controls may result in damage and will often require extensive work by a qualified
technician to restore the product to normal operation.
E. If the product has been dropped or the cabinet has been damaged.
F. If the product exhibits a distinct change in performance.
13. Avoid using a telephone (other than cordless type) during an electrical storm. There may be a
remote risk of electric shock from lightning.
14. Do not use the telephone to report a gas leak in the vicinity of the leak.
SAVE THESE INSTRUCTIONS
IMPORTANT INSTRUCTIONS TO USERS
Your model (IT-A100 or IT-A200) has been approved by the Federal Communications Commission
(FCC) as not being harmful to the telephone network when connected directly to the telephone lines.
In order to fully comply with the Rules of the FCC Part 68, the following instructions should be read
carefully and followed completely where applicable:
1. The FCC Rules require that all direct connection to the telephone lines must be made through
standard plugs and jacks as called out in the Rules.
No connection can be made to party lines or coin lines.
a. Upon request from your telephone company, you must provide the 14 digit FCC Registration
Number and Ringer Equivalence Number (REN), both of which are on a label located at the
bottom of the unit.
b. Inform your local telephone company that the jack (connector) required for your device is
USOC RJ11C. The plug and jack comply with the Rules of the FCC Part 68.
c. After the telephone company has installed the jack listed above, you can connect your model
(IT-A100 or IT-A200) by inserting the mating plug of your equipment into the jack.
d. The REN is useful to determine the quantity of devices you may connect to your telephone
line and still have all of those devices ring when your number is called. In most, but not all
areas, the sum of the RENs of all devices should not exceed five (5.0). To be certain of the
number of devices you may connect to your line, as determined by the REN, you should call
your local telephone company to determine the maximum REN for your calling area.
e. All repairs must be accomplished as described in the “Service requirements”.
2. If it appears that your model (IT-A100 or IT-A200) is malfunctioning, it should be disconnected
from the telephone line until it can be determined if your equipment or the telephone line is the
source of the trouble. If your equipment needs repair, it should not be reconnected until such
repairs are made.