Nevercoverthe slots and openings aD
with a cloth or other materials. _
Never block the $ints and openings
by placin_ the set on a bed, sofa, rug
or other s.milar surface.
Never piao_ the set in a confined
spice, such as a bookcase or built-in
cabinet, unless proper ventitation is
provided.
Do not p ace the set near or over a
radiator or heat register, or where it is _. _, ,_.
exposed to dire_t suuli_t.
Power-Cord Protection
Do not aJlow anyiging to rest oa or _011over.the
power cord, and do not place the set where me
_ower cord is subject to wear or abuse.
Antennas
Outdoor Antenna Grounding
If an outdoor antenna is installed, follow _e p_c .aufi_o_ in
below. An outdoor a_tenna syst_ sho_x_ not be t°c.ac_, r
the vicinity of overhead power lines or other elect_c ggm o
power circuits, or where it can come in conLaci with such
power lines or circuits.
WHEN INSTALLING AN OUTDOOR ANTENNA
SYSTEM, EXTREME CARE SHOULD BE TAKEN TO KEEP
FROM CONTACTING SUCH POWER LINES OR
CIRCUITS AS CONTACT WITH THEM iS ALMOST
ENXIAR1 ABLY FATAL.
Be sure the antenna s stem is grounded so as to provide some
protection against vSo_age surges and built-u_.s_tic .charges.
_pctinn 810 of the National Eiect_al Code (_-J m u_A and
Section 54 of the Canad_aa Electrical Code m Cana
provides information with respect to p.rppoz _o_inf_ o_
ma_t and suvvortin_ structure, grou_admg ot me leaa-m
location of antenna dLscbarge umt, cotmection to _grou_Jiemg
electrodes, and requirements for the grounding eiecrrou .
Antenna Grounding According to the NE¢
Antenna Groundin_ According to fire Natlo_al Etectrical
Code, ANSI/NFPA 70.
NE_ NAT_ _'V_4C CCOE
6qEc SLa_TIO_ 8t_20_
G_O_lO_qG O3_OoCIOt_
S_CI_(_N 810=21 )
pO_'_R SlER_E (_OUkO _G
Lightning
tighmingstorm,orwhen_t_slen.unattan_u_a_,au_.,_-. •
for lon_ periods of time, unplug zt _ the w_ea ouuet ema
d isc_ra_ct the antenna. This wig prevent damage to the
_ecei--vet due to llghtni_g and power-_e surges.
Service
Damage Requiring Service
LI_phx_ the set from the wall outlet and refer servicin_ to
qualified service persoxmel under the following conditions:
When the power cord or plug
Ls_ed or frayed. _--_=,,=
If liquid has been spilled
into the I_otor objects have
fallen into the product.
If the set has bee_ exposed to
l_in or water.
If the set has been subject to
excessive shock by bein_
dropped, or the cabinet ttas
been damaged.
If the set does not op_.=te .
normalfy when followmg the operating _ _l
instructions. Adjust only those controls _
that are specified in the o_-,ratlng . /_'/
insl_ucttens. Improper ad]us_ent ot
ott_ _otmls may result m dama and
will often re9 "m_. extenssve work_y a
qualified teclmlcia_ to t_tore the set to normal 0peralio_
When the set exhibits a distinct chan in
pedormance -- this indicates a need _or service.
Servicing
Do not attempt to service the set yourself _,
since opevlng the cabk_ may expose you
to danserous voltage or other bazard_ Refer
all servicing to qualified service pe_oea_eL
Replacement Parts _
When _eptacemeatparts are _=q_ui_., be
sure the servioe tochnicima cerfafies m
writing that he has used replaoement
varts specified by the manufacturer that
have tile same characte_stic_ as the
original _,arts. Unauthorized
substituttor_s m_y result in fire, elecmc
shock, or other hazards.
Safety Check
Upon completion of any service or repairs to _.
the set, ask the service techulaan to Pethffeorm
routine safety checks (as specified by . in
manuJactutex) to deto x'_ap-e that the set Is
safe operating condition, and to.so ce ,r_...,
W_ten the set reaches the eno ot ztsusetu_me, , ,.
i_proper disposal could result in a picture
hawiosion, Ask a qua]Lfled service
technlo_an to dispose of the set.
To Next Page
Loading...
