HCD-SHAKE99/HCDSHAKE100
77
Pin No. Pin Name I/O Description
57 to 60 RD4 to RD7 I/O Two-way data bus with the SD-RAM
61 DQM0 O Data mask signal output to the SD-RAM (lower byte)
62 to 69 RD15 to RD8 I/O Two-way data bus with the SD-RAM
70 DQM1 O Data mask signal output to the SD-RAM (upper byte)
71 DVDD33 - Power supply terminal (+3.3V) (digital system)
72 RCLK O Clock signal output to the SD-RAM
73 to 79 RA11, RA9 to RA4 O Address signal output to the SD-RAM
80 RWE# O Write enable signal output to the SD-RAM
81 DVSS12 - Ground terminal (digital system)
82 CAS# O Column address strobe signal output to the SD-RAM
83 RAS# O Row address strobe signal output to the SD-RAM
84 DVDD33 - Power supply terminal (+3.3V) (digital system)
85, 86 BA0, BA1 O Bank address signal output to the SD-RAM
87 DVDD12 - Power supply terminal (+1.2V) (digital system)
88 to 92 RA10, RA3 to RA0 O Address signal output to the SD-RAM
93 SPDIF O SPDIF signal output terminal Not used
94 XMAMUTE O Audio muting control signal output terminal Not used
95 NC - Not used
96 DACVDDC - Power supply terminal (+3.3V) (for D/A converter)
97 VREF - Band-gap reference voltage terminal
98 FS - Full scale adjustment terminal
99 DACVSSC - Ground terminal (for D/A converter)
100 CVBS O Composite video signal output terminal Not used
101 DACVDDB - Power supply terminal (+3.3V) (for D/A converter)
102 SY/Y/G O Component video (Y) signal output terminal Not used
103 SC/CB/B O Component video (Cb/Cb) signal output terminal Not used
104 CR/R O Component video (Cr/Pr) signal output terminal Not used
105 AADVSS - Ground terminal (for A/D converter)
106 ADIN I Audio data input from the A/D converter
107, 108 NC - Not used
109 AADVDD - Power supply terminal (+3.3V) (for A/D converter)
110, 111
ADACVSS2,
ADACVSS1
- Ground terminal (for D/A converter)
112 ACLK O Master clock signal output to the audio A/D converter
113 ABCK O Bit clock signal output to the audio A/D converter and sample rate converter
114 NC - Not used
115 AVCM - Audio D/A converter reference voltage terminal
116 NC - Not used
117 ALRCK O L/R sampling clock signal output to the audio A/D converter and sample rate converter
118 ASDATA0 O Audio data output to the sample rate converter
119, 120
ADACVDD1,
ADACVDD2
- Power supply terminal (+3.3V) (for D/A converter)
121 AVDD12 - Power supply terminal (+1.2V) (analog system)
122 AGND12 - Ground terminal (analog system)
123, 124 RFIP, RFIN/OPOUT I AC coupled RF signal input from the optical pick-up block
125 IOPMON/OPINP I Power monitor terminal
126 SPFG/OPIN I Spindle motor hall sensor input from the motor driver
127 RF_A I RF main beam (C) input from the optical pick-up block
128 RF_B I RF main beam (B) input from the optical pick-up block
Ver. 1.1
To Next Page
Loading...
