Sony SLV-340 - Recording TV Programs

Recording TV
programs
Tips
¢ To select channels, you can
also use the number buttons
on the remote commander.
Enter the desired channel
number using the number
buttons, then press ENTER.
If you don’t want to watch
TV while recording, you can
turn off the TV. When using
a cable box, make sure to
leave it on.
(continued)
CH +/-
TAPE SPEED
@ REC
This section shows you how to, record TV programs in the most basic
way: manual recording. With manual recording, you start the VCR
recording when the program begins, then stop it when the program
ends. The VCR also provides the following ways of recording.
¢ Manually start recording, then stop it automatically—“Recording
using the quick timer” (page 24)
¢ Automatically start and stop recording—“Recording TV programs
using the timer” (page 26)
1 Turn on your TV and tune in to the
VCR:
¢ If the TV is connected to the VCR
using the audio/video cable, set the
TV to video input.
¢ Ifthe TV is connected to the VCR
using only the antenna cable, set the
TV to the channel for the VCR.
When using a cable box, turn it on.
2 insert a tape with its safety tab in
place.
3 Press CH +/- until a desired
channel number appears in
the VCR’s display window.
4 Select the tape speed, SP or
EP, by pressing TAPE SPEED.
See “To select tape speeds” on the
next page.
5 Start recording by pressing @ REC.
When the tape reaches the end, the VCR
automatically rewinds it to the beginning.
To stop recording
Press @ STOP.
Basic Operations | 23 -EN