To stop recording
To stop the VCR while recording, press • STOP.
To use the VCR after setting the timer
To use the VCR before a timer recording begins, just press I/_. The
indicator disappears from the display window and the VCR switches on.
Remember to press I/_ to reset the VCR to the timer recording standby
mode after using the VCR.
Tips
• The program is recorded in the current tape speed. To change the tape speed, press
SP/EP before you complete the setting in step 7.
• To check, change, or cancel the program setting, see "Checking/changing/canceling
timer settings" (page 93).
Notes
• If eight programs have already been set in step l, "FULL" appears in the display
window for about three seconds.
• If you are using cable box control, you cannot select "LI" or "L2."
• The @ indicator flashes in the display window when you complete the setting in
step 7 with no tape inserted.
• If "CLOCK" and "12: - - AM" appear alternately when you press the DIAL TIMER
control, set the clock to use the Dial Timer function (page 37).
Additional Operations I 91
To Next Page
Loading...
