Sony STR-DN850 - Page 144

MULTI CHANNEL AV RECEIVER
STR-DN1050/STR-DN850
Selecting the Auto Calibration type (Calibration Type)
You can select a calibration type after you have performed the Auto Calibration and saved the settings.
1. Select [Settings] - [Speaker Settings] from the home menu.
2. Select [Calibration Type].
3. Select the setting you want.
Full Flat: Makes the measurement of frequency from each speaker flat.
Engineer: Sets to “the Sony listening room standard” frequency characteristics.
Front Reference : Adjusts the characteristics of all of the speakers to match the characteristics of the front
speaker.
Off
Note
This function does not work in the following cases:
[2ch Analog Direct] is being used.
Headphones are connected.
The receiver may play signals at a lower sampling frequency than the actual sampling frequency of the input signals,
depending on the audio format.
Hint
You can also select [Calibration Type] in [Sound Effects] from the home menu.
Notes on use
4-488-938-11(1)
Copyright 2014 Sony Corporation
Help Guide
133