MULTI CHANNEL AV RECEIVER
STR-DN1050/STR-DN850
Selecting the speaker pattern and setting the assignment for the speaker terminals (Speaker Connection/SB
Speaker Assign)
You can select the speaker pattern and set the assignment for the SPEAKERS SURROUND BACK/BI-AMP/FRONT
HIGH/FRONT B terminals.
1. Select [Settings] - [Speaker Settings] from the home menu.
2. Select [Speaker Connection].
3. Select the speaker pattern you want.
4. Set [SB Speaker Assign] to any of the following settings (*).
Zone2 (for STR-DN1050 only)
When using the zone 2 connection.
Bi-Amp
When using the bi-amplifier connection.
Front B
When using the front B speaker connection.
Off
When none of the connections above are used.
*
The displayed settings vary depending on the speaker pattern you selected in step 3.
Note
You can only set [SB Speaker Assign] if the speaker pattern is set to a setting that does not have surround back and
front high speakers.
Related Topic
Connecting speakers
Notes on use
4-488-938-11(1)
Copyright 2014 Sony Corporation
Help Guide
To Next Page
Loading...
