MULTI CHANNEL AV RECEIVER
STR-DN1050/STR-DN850
Preparing for “BRAVIA” Sync
Turn on the Control for HDMI function of the receiver and the connected device to individually.
1. Select [Settings] - [HDMI Settings] from the home menu.
2. Select [Control for HDMI].
3. Select [On].
The Control for HDMI function of the receiver is turned on.
4. Press HOME to exit the GUI menu.
5. Select the HDMI input of the receiver and TV to match the HDMI input of the connected device, so that the image
from the connected device is displayed.
6. Turn on the Control for HDMI function of the connected device.
For details on setting the TV and connected device, refer to the operating instructions of the respective devices.
7. Repeat steps 5 and 6 for other devices for which you want to use the Control for HDMI function.
Note
Perform the steps above again if you unplug the HDMI cable or change the connection.
Notes on use
4-488-938-11(1)
Copyright 2014 Sony Corporation
Help Guide
To Next Page
Loading...
