MULTI CHANNEL AV RECEIVER
STR-DN1050/STR-DN850
Selecting the source signals for zone 2 (Input) (for STR-DN1050 only)
You can select the source signals for zone 2 using the following procedure.
1. Select [Settings] - [Zone Settings] from the home menu.
2. Select [Input].
3. Select the source signals you want to output.
Hint
You can also select the source signals for zone 2 using ZONE CONTROL and INPUT SELECTOR on the receiver
while [2. xxxx (input name)] is shown on the display panel.
Notes on use
4-488-938-11(1)
Copyright 2014 Sony Corporation
Help Guide
To Next Page
