MULTI CHANNEL AV RECEIVER
STR-DN1050/STR-DN850
Reverting to the factory default settings
You can clear all memorized settings and restore the receiver to the factory default settings by the following procedure.
This procedure can also be used to initialize the receiver before you use it for the first time.
Be sure to use the buttons on the receiver to perform this operation.
1. Turn off the receiver.
2. Hold down (on/standby) on the receiver for 5 seconds.
[CLEARING] appears on the display panel for a while, then changes to [CLEARED!] .
Note
It takes a few minutes for the memory to be cleared completely. Do not turn the receiver off until [CLEARED!] appears
on the display panel.
Notes on use
4-488-938-11(1)
Copyright 2014 Sony Corporation
Help Guide
To Next Page
