Sony Trimaster EL BVM-E250 - Page 70

70
Function Setting Menu
Chapter 3 Menu
Function Switch
L/R Switch Sets whether or not to display either the left and right 3D video signals on the screen by
switching them alternately ([Off] or On).
This item is available for dual-stream HD-SDI signals.
Notes
• The L/R Switch display cannot be set in the following cases:
– When the option port number in which the BKM-250TG is installed is not selected in
Input Port of the Channel Configuration menu
– When dual-link display is used
– When the internal signal is displayed
– When a captured frame is displayed
– When Side by Side, Wipe, Butterfly or Blending is set to On
• The L/R Switch display may not be performed correctly when H Delay is set to On.
• If saving is performed in HD Frame Capture, this function is deactivated and the normal
display is restored.
Horopter Check Sets whether or not to display the left and right 3D video signals in various modes ([Off] or
On).
This item is available for dual-stream HD-SDI signals.
Notes
• The Horopter Check display cannot be set in the following cases:
– When the option port number in which the BKM-250TG is installed is not selected in
Input Port of the Channel Configuration menu
– When dual-link display is used
– When the internal signal is displayed
– When a captured frame is displayed
– When Side by Side, Wipe, Butterfly or Blending is set to On
• The Horopter Check display may not be performed correctly when H Delay is set to On.
• If saving is performed in HD Frame Capture, this function is deactivated and the normal
display is restored.
Flip H Sets whether or not to invert the 3D video signals horizontally to be displayed ([Off] or On).
This item is available for dual-stream HD-SDI signals.
Notes
• The Flip H display cannot be set in the following cases:
– When the option port number in which the BKM-250TG is installed is not selected in
Input Port of the Channel Configuration menu
– When dual-link display is used
– When the internal signal is displayed
– When a captured frame is displayed
– When Side by Side, Wipe, Butterfly or Blending is set to On
• The Flip H display may not be performed correctly when H Delay is set to On.
Menu Function and operation ([ ]: factory setting)