69
Function Setting Menu
Chapter 3 Menu
Function Switch
Error Notify Clear When the item is selected, the notification of the gamut error detection (OSD Notification) is
cleared.
Note
The Error Notify Clear is not selected in the following cases:
• When Gamut Error Display is set to Off in the Gamut Error Display menu of the Function
Setting menu.
• When OSD Notification Reset is set to Auto in the Gamut Error Display menu of the
Function Setting menu.
Audio Level Meter Sets whether or not to display the audio level meter ([Off] or On).
Note
When the option port number in which the BKM-250TG is installed is not selected in Input
Port of the Channel Configuration menu, the audio level meter cannot be displayed.
ALM Hold Reset When the item is selected, the peak hold of the audio level meter is canceled.
Note
The ALM Hold Reset is not selected in the following cases:
• When the option slot number in which the BKM-250TG is installed is not selected in Input
Port of the Channel Configuration menu
• When Audio Level Meter is set to Off
• When Peak Hold is set to Off or Auto in the Audio Level Meter menu of the On Screen Set
menu of the System Configuration menu
Time Code Sets whether or not to display the time code ([Off] or On).
Difference Sets whether or not to display the difference between the luminance of the left 3D video
signal and that of the right signal ([Off] or On).
This item is available for dual-stream HD-SDI signals.
Notes
• The Difference display cannot be set in the following cases:
– When the option port number in which the BKM-250TG is installed is not selected in
Input Port of the Channel Configuration menu
– When dual-link display is used
– When the internal signal is displayed
– When a captured frame is displayed
– When Side by Side, Wipe, Butterfly or Blending is set to On
• The Difference display may not be performed correctly when H Delay is set to On.
• If saving is performed in HD Frame Capture, this function is deactivated and the normal
display is restored.
Checkerboard Sets whether or not to display the left and right 3D video signals in a checkerboard pattern
([Off] or On).
This item is available for dual-stream HD-SDI signals.
Notes
• The Checkerboard display cannot be set in the following cases:
– When the option port number in which the BKM-250TG is installed is not selected in
Input Port of the Channel Configuration menu
– When dual-link display is used
– When the internal signal is displayed
– When a captured frame is displayed
– When Side by Side, Wipe, Butterfly or Blending is set to On
• The Checkerboard display may not be performed correctly when H Delay is set to On.
• If saving is performed in HD Frame Capture, this function is deactivated and the normal
display is restored.
Menu Function and operation ([ ]: factory setting)
To Next Page
Loading...
