Sony Trinitron KV-20V80 - Inserting Batteries; Using the Remote Control Move; Select Buttons; Adjustments Bars

MM® Basic Set up
Inserting batteries
Insert two size AA (R6) batteries (supplied) by
matching the + and - on the batteries to the
diagram inside the battery compartment.
Notes
¢ Remove the batteries to avoid damage
from possible battery leakage whertever ~
you anticipate that the remote control will
not be used for an extended period.
¢ Handle the remote contro] with care.
Avoid dropping it, getting it wet, or
placing it in direct sunlight, near a heater,
or where the humidity is high.
e Your remote control can be programmed to
operate most video equipment. (see page 26)
12
Using the remote control,
Move & Select buttons
Kea} Select
The supplied remote control has "arrow"
buttons (#, #, €, ®) which allow for
movement of the on-screen selector in four
directions. Pressing on the outer buttons will
cause the selector to move in the
corresponding direction. Pressing the center
button (<=> ) will select the item.
Adjustments bars
When menu items present an adjustment bar
(iii: 0 OT rutin), Use the arrow buttons to
change the setting.
On-Screen Help/instructions
Several menu windows will provide prompts
and instructions to assist you in navigating
through the different functions. When
presented, use these to supplement the tnstructions
in this manual.
Note
¢ To reset your TV to factory settings, turn
the TV on. Then, while pressing the RESET
button, press the POWER key on your TV.
The TV will turn itself off, then back on.
(except KV-20V80).