Sony UP-897MD - Initialization of Setting; Switching of Continuous Setting (C) in Number; Of Printed Sheets (QTY); Switching of REMOTE Capture Timing

Error ID
ID
1102h
1103h
1105h
1204h
1301h
1302h
1303h
1305h
1401h
1404h
1501h
2100h
2200h
2300h
2400h
3100h
5100h
6101h
6102h
5-10.
Factor
Head cannot be moved from home position to printing position. (During printing)
Head cannot be moved from home position to printing position. (During feeding)
Head cannot be moved from home position to printing position. (During cleaning)
Head cannot be moved from home position to door open position. (During door open)
Head cannot be moved from printing position to home position. (During mechanical initialization)
Head cannot be moved from printing position to home position. (During printing)
Head cannot be moved from printing position to home position. (During feeding)
Head cannot be moved from printing position to home position. (During cleaning)
Head cannot be moved from door open position to home position. (During mechanical initialization)
Head cannot be moved from door open position to home position. (During door open)
Head cannot be moved from arbitrary position to any of the positions (printing/home/door open). (During mechanical initialization)
Thermistor is shorted. (Abnormally high temperature)
Head is not connected. (Abnormally low temperature)
Preheat time out
Cool down time out
Front paper sensor detects “no paper” during printing.
Print pulse time out
Prestart time out
Paper feed before printing time out
Initialization of Setting
RESET R:ALL
UP-897MD
R:FAN
R.H.PRN
R:MENU
BACK
Resets the unit to the factory
setting.
Resets the fan ON time.
This is performed when replacing
the fan.
Resets the print count record to “0”.
This is performed when the head is
replaced.
Jnitializes the contents that are set
in the menu.
Returms to RESET.
5-11. Switching of Continuous Setting (C)
in Number of Printed Sheets (QTY)
It is switched whether to display “QT.C” for continuous
print setting in a “QTY” menu.
The factory setting is “Q.C:OFP”.
QTY.C Q.C:ON When enabling the selection of
continuous printing
Q.C:OFF When disabling the selection of
continuous printing
BACK Returns to QTY.C.
5-12. Switching of REMOTE capture
timing
The timing from when a PRINT signal is input to the
REMOTE terminal on the front panel until it is captured is
switched.
The factor setting is “RM:NOR”.
RMCAP RM:JST — Just mode
RM:NOR_ Normal mode
BACK Returns to RMCAP.
5-5