Factory Settings
All settings can be reset, returning the controller to its delivery state.
All of the controller‘s parametrization, statistics, etc. will be lost irrevocably. The controller must then be commissioned once
again.
Eco Display Mode
In Eco Display Mode the backlight of the display is switched off if no buttons are pushed for 2 minutes.
If a message exists, the backlight does not switch off until the message has been scanned by the user.
Network
If necessary, the network settings of the connected data logger must be set.
Access Control
This menu lets you give up to 4 users access to the data logger. The users that are registered then have access to the controller or
respectively the data logger.
To
ad
d
a
use
r
in
the
l
i
st
,
se
l
ect
<ad
d
use
r>.
L
e
a
ve
t
h
e
no
w
vi
si
bl
e
me
n
u
op
e
n
u
nd
co
n
n
ect
to
t
h
e
a
dd
re
ss
of
the
co
n
n
ector
or
resp
e
ct-
ively the data logger. Your user name is going to appear in this menu and can be selected and confirmed with ‘OK’.
Note
You can find the address of the connector or respectively the data logger on the address sticker on the outside of the casing. Pointers
and help on how to establish a connection you can find in the enclosed SOREL Connect instructions or the instructions of the data log-
ger.
Select a user with ‚OK‘ to grant access.
To revoke access again, choose one of the users from your list and choose <remove user>.
Ethernet
The data logger‘s Ethernet connection settings can be set using this menu.
MAC Address
Displays the individual MAC address of the data logger.
Auto-Configuration (DHCP)
If auto-configuration is activated, the data logger requests IP addresses and network parameters from a DHCP server that assigns an
IP address, subnet mask, gateway IP and DNS server IP. If you deactivate the auto configuration (DHCP), you will have to make
the required network settings manually!
IP-Address
Please refer to the router configuration for the IP address to be set.
Subnet Mask
Please refer to the router configuration for the subnetz mask to be set.
Gateway
Please refer to the router configuration for the gateway to be set.
DNS-Server
Please refer to the router configuration for the DNS server to be set.
43
To Next Page
Loading...
