SOYO SY-7VBA133U - CPU and Memory Installation Procedures

Hardware Installation
SY-7VBA133U
22
2-3.1 CPU Installation
Your SY-7VBA133U motherboard comes with a CPU retention set kit.
The retention set is used to hold the processor attached to the Socket 370
CPU connector on the motherboard.
Mark your CPU Frequency:
Record the working frequency of
your CPU that should be clearly marked on the CPU cover.
FSB 66MHz
400MHz ( 66 x 6.0 ) 500MHz ( 66 x 7.5 ) 600MHz ( 66 x 9.0 ) 700MHz ( 66 x 10.5 )
433MHz ( 66 x 6.5 ) 533MHz ( 66 x 8.0 ) 633MHz ( 66 x9.5 ) 733MHz ( 66 x 11.0 )
466MHz ( 66 x 7.0 ) 566MHz ( 66 x 8.5 ) 667MHz ( 66 x10.0 ) 766MHz ( 66 x 11.5 )
FSB 100MHz
500MHz(100x 5.0)
600MHz(100x 6.0)
700MHz(100x 7.0)
800MHz(100x 8.0)
900MHz(100x 9.0)
550MHz(100x 5.5)
650MHz(100x 6.5)
750MHz(100x 7.5)
850MHz(100x 8.5)
950MHz(100x 9.5)
FSB 133MHz
533MHz(133x 4.0)
667MHz(133x 5.0)
800MHz(133x 6.0)
933MHz(133x 7.0)
1.13GHz(133x8.0)
600MHz(133x 4.5)
733MHz(133x 5.5)
866MHz(133 x6.5)
1GHz (133 x 7.5)
1.2GHz (133x 8.5)
CPU Mount Procedure:
To mount the Pentium®, Celeron
TM
, Tualatin
processor that you have purchased separately, follow these instructions.
1. Lift the socket handle up to a vertical position.