SOYO SY-7VBA133U - 2-3.5 Power on

Hardware Installation
SY-7VBA133U
41
2-3.5 Power On
You have now completed the hardware installation of your Motherboard
successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the system
is performing the diagnostic checks,
Note:
If you have failed to enter the BIOS, wait until the boot up
sequence is completed. Then push the RESET button and press
<DEL> key again at the beginning of boot-up, during diagnostic
checks.
Repeat this operation until you get the following screen.
3. The BIOS Setup screen appears:
CMOS Setup Utility – Copyright ( C ) 1984-2001 Award Software
SOYO COMBO Feature PC Health Status
Standard CMOS Features Load Optimized Defaults
Advanced BIOS Features Load Fail - Safe Defaults
Advanced Chipset Features Set Supervisor Password
Integrated Peripherals Set User Password
Power Management Setup Save & Exit Setup

PnP/PCI Configurations
Exit Without Saving
Esc : Quit  : Select Item
F10 : Save & Exit Setup
Change CPU’s Clock & Voltage