Spaceman 6224 - Page 15

Page12
Section5 Important: Operating Control
- Press the STANDBY button to increase the value.
- Press the P button to decrease the value.
2. Press RESET button once, fluorescent display indicates:
- In COOL and STANDBY cycle, machine will start to cool mix in hopper when
temperature of mix in hopper is 1 degree higher than above value. And stop it
when the temperature is 1 degree lower. In the STANDBY cycle, same function for
mix in cylinder.
- Press the STANDBY button to increase the value.
- Press the P button to decrease the value.
3. Press RESET button once, fluorescent display indicates:
- Set the date and time.
- Press the STANDBY button to increase the value. Press the P button to decrease
the value.
- Press COOL button to set next parameter.
- To save the changes on this screen, you must press and hold ICE CREAM button
for 3 seconds. After it is saved, the screen will jump out of the SET MENU
automatically. If press RESET button, this adjustment will NOT be saved.
4. Press RESET button once, fluorescent display indicates:
- Set the automatic program at set time.
- For example:
P: 1 08:00 start COOL mode at 08:00 every day.
P: 2 21:00 start WASH mode at 21:00 every day.
P: 3 22:00 start STANDBY mode at 22:00 every day.
- Press the STANDBY button to increase the value. Press the P button to decrease
the value.
- Press COOL button to set next parameter.
- P: 0 is no automatic program. There are 1 hour at least between COOL and other
program.
- To save the changes on this screen, you must press and hold ICE CREAM button
for 3 seconds. After it is saved, the screen will jump out of the SET MENU
automatically. If press RESET button, this adjustment will NOT be saved.
MIX TEMPERATURE
L SET: 4.5C
P: 0 00 : 00
P: 0 00 : 00
2011 /01 /16
14 : 47 :58