Page 1
Section1 To the installer
Air Cooled Units
The model 6224 ice cream machine’s air cooling unit requires a minimum of 15.2cm of
clearance around both sides. Install the skirt provided on the right side of the unit and
place the back of the unit against a wall to prevent recirculation of warm air.
Electrical Hook-Up Installation for 220 Volt/ 50Hertz/ 1 Phase, Supplied With Cord
and Plug
This equipment is supplied with a 3-wire cord and grounding type plug for connection to
a single phase, 220 volt, 50 hertz, branch circuit supply. This unit must be plugged into
a properly grounded receptacle. The cord and plug provided for is 30 amp; therefore the
wall outlet must also be 30 amp. Check the data label, located in the side panel, for
electrical specifications. The plug should be accessible after installation.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified person in order to avoid a hazard.
Permanent wiring may be employed if required by local codes. Instructions for
conversion to permanent wiring are as follows:
1. Be sure the freezer is electrical disconnected.
2. Remove the appropriate panel and locate the small electrical box at the middle of the
freezer.
3. Remove the factory-installed cord and strain relief bushing.
4. Route incoming permanent wiring through hole in base pan.
5. Connect two power supply leads. Attach ground (earth) wire to the grounding lug
inside the electrical box.
6. Be sure the unit is properly grounded before applying power.
CAUTION: THIS EQUIPMENT MUST BE PROPERLY GROUNDED! FAILURE TO DO
SO CAN RESULT IN SEVERE PERSONAL INJURY FROM ELECTRICAL SHOCK!
SPECIFICATIONS
MODEL 6224
FLOOR MODEL，GRAVITY FREEZER
DIMENSIONS:
Freezer: 40.4cm wide × 74.3cm deep × 68.4cm high
Packing: 55.0cm wide × 77.0cm deep × 89.0cm high
WEIGHT
Freezer: 115kg Packing: 129kg
To Next Page
Loading...
