Page22
Section6 Operating Procedures
Step 6
Remove the rear drip pan from the side panel and take it to the sink for cleaning.
Note: If the drip pan is filled with an excessive amount of mix, this is an indication that the
drive shaft O-ring of the beater assembly should be replaced or properly lubricated.
Step 7
Thoroughly brush clean all disassembled parts in the cleaning solution. Make sure all
lubricant and mix film is removed. Take particular care to brush clean the draw valve
core in the freezer door. Place all the cleaned parts on a clean, dry surface to air dry
overnight.
Step 8
Wipe clean all exterior surfaces of the freezer.
To Next Page
Loading...
