Spaceman 6350 - Operating Control; Introduction


：A mix level indicang light is located at the front of the machine. When the light is
“ON”, it indicates that the mix hopper has a low supply of mix and should be relled as soon as possible.
Always maintain at least 2cm of mix in the hopper. If you neglect to add mix, a freeze-up may occur. This will
cause eventual damage to the beater assembly, the dispensing door, and gear box.
：During normal operaon the display is used to indicate funcon, the temperature of the
mix in the hopper and cylinder, the electric current of beater motor, error, and warning message.
：To beer communicate in the Internaonal arena, symbols have replace words on
many of your operator switches. SPACEMAN equipment is designed with these internaonal symbols.
  
  
Turn on power
Press and hold RESET for 3 seconds to enter into Menu;
Press RESET to turn to next page

Press RESET buon
to turn to STOP
mode
Press WASH buon
to turn to WASH
mode
Press P buon,
displays temperature
of Hopper & Cylinder
Press STANDBY
buon to turn on
STANDBY mode
Press FREEZE buon
to turn on FREEZE
Mode
Press ICE CREAM
buon, screen displays
dispense count
Press P buon
again, displays
motor current
Viscosity Seng
Hopper
Temperature
Date & Time


 
 
 
 
 
 
Auto Programming Language
Mix Low
Indicator Touch Switch
Panel
Display Screen