Spaceman requires that only the specied
refrigerant be used in your machine.
Alternave refrigerants may cause damage to
the cooling system and/or prevent the machine
from operang at opmal performance.
If you require an alternave refrigerant, please
call Spaceman Technical Support for a list of
compable alternaves for your compressor.
• Place on a at, level, and solid surface ed to the
machine dimensions.
• Ensure a minimum 152mm (6'') clearance on the
exhaust side (Side or Back); units with
installed do not need to meet this clearance
requirements.
• Completely clear area of dust, grease, and airborne
parcles.
• Place away from hot equipment such as stoves, frying
baskets, ovens, etc.
Failure
to comply will damage the machine and
refrigeraon components and will void all
warranes.
Operang in higher ambient temperatures
will result in degraded performance.
1. Connect all wires to Circuit Breaker (including neutral &
ground bus terminals) or Local Plug according to supply
voltage and wire codes on machine power cable.
2. Verify Incoming Supply Cable is wired the same way on
Circuit Breaker or Wall Receptacle before switching on
or plugging in the machine.
Switch on power and verify that motor turns clockwise as
per Red Arrow on motor pulley. If not, switch any two line
wires on Circuit Breaker or Plug and verify again.
Machine will
work properly and
WILL be damaged if motor
turns in wrong direcon.
The image displayed is for illustraon purpose only and may
dier from the actual product.
To Next Page
Loading...
