Spaceman 6350 - OPERATING CONTROL: MODES (Page 17); WASH MODE; STANDBY MODE; DEFROST MODE






In STANDBY, product remains below 4
o
C (40
o
F) in both the cylinders and hoppers, but will NOT be frozen.

• Press RESET buons, then STANDBY buons
• Displays read STANDBY when machine is in STANDBY mode

• Press RESET buons
• Machine is ready for a new mode selecon


• Press RESET buon, then WASH buon
• Displays read WASHING when machine is in Wash mode

• Press RESET buon
• Machine is ready for a new mode selecon

• Press RESET buon, then STANDBY for 3 seconds
• Displays read DEFROST when machine is in DEFROST mode

• Press RESET buon
• Machine is ready for a new mode selecon

Heat up frozen product in cylinder for faster draining and cleaning.
Use right before draining; start draining aer it completes in 3 to 5 minutes.


1. With machine in FREEZE mode, remove air tubes.
2. Clean air tubes, hopper agitators, design cap, front
trip tray, and internal trip tray.
3. Insert into machine upside down (inlet hole on the
side of the air tube at the top).
4. Conrm product is above minimum product level
(top of hopper agitator blade) in hoppers.
5. Press RESET, press STANDBY.

1. Open draw handles to draw 170 g to 227 g (6 oz. to 8
oz.) of product; discard product.
2. Press RESET, press FREEZE. Wait unl machine nish-
es freeze cycle and motors stop turning.
3. Insert air tubes into machine with correct orientaon
(inlet hole on the side of the air tube at the boom).
4. Machine is ready for normal operaon.

1. Clean hopper covers, hopper agitators, design
cap, front trip tray, and internal trip tray.
2. Conrm product is above minimum product
level (top of hopper agitator blade) in hoppers.
3. Press RESET, press STANDBY.

1. Open draw handles to draw 170 g to 227 g (6
oz. to 8 oz.) of product; discard product.
2. Press RESET, press FREEZE. Wait unl machine
nishes freeze cycle and motors stop turning.
3. Machine is ready for normal operaon.

