Spaceman 6350 - QUICK OPERATION GUIDE; INSTALLATION AND SETUP; CLEANING AND PREPARATION; OPERATION





Unpack and inspect
machine, parts, and
accessories.
Place machine in appropriate food
preparaon area. Comply with all
installaon requirements.
Read and understand
ALL safety and standard
operang procedures.
Fully disassemble machine,
and prepare parts for
cleaning.
Thoroughly clean and scrub
machine hoppers, cylinders,
and all parts.
Lubricate and re-assemble
all machine parts.

Prepare product in a sepa-
rate container, and ensure
product is thoroughly mixed.
Add product to hoppers
and prime the cylinder
using the prime plug.
Turn machine to FREEZE
mode, and wait for product
to reach frozen consistency.
Slightly adjust viscosity
seng as necessary to
adjust product rmness.

Inspect the machine for any shipping damage. If you nd any, contact Spaceman Technical Service immediately
aer unpallezing. Our technicians will help you assess the damage and determine the appropriate acon prior
to accepng the delivery.

1. Cut packing straps, and remove cardboard lid and outer sides from the pallet. DO NOT cut cardboard.
2. Remove plasc wrapping around machine.
3. Cut stabilizing straps, being careful not to scratch or dent the machine panels.
4. Prepare the area where the machine will be placed, remove packing cardboard from underneath machine,
and place ramp wedges near front casters.
5. Unlock front casters, and roll machine down the wedges o the pallet.
6. Place the machine in its nal locaon according to the Installaon Requirements.
: Unpallezing requires liing. 
Failure to do so may result in
severe injury or damage. Inspect equipment for hidden damage before signing for delivery.

Refer to the detailed parts diagrams on the back pages if necessary.
1. Remove all packaged parts and accessories from your machine.
2. Organize items on a clean table or operang area using the checklist.
3. Inspect for damage immediately upon unpacking and call Spaceman
Technical Service if you discover any damaged or missing parts.
4. Clean and properly lubricate machine parts prior to machine operaon.
Included Parts:
• Hopper Cover (1 or 2)
• Front Drip Tray + Splash Shield
• Dispensing Handles (1 or 3)
• Retenon Pin with Nut
• Start-Up Kit
• Operator’s Manual

  
   
  
Fully sanize machine.