Spaceman 6350 - PREPARATION: SANITIZE (Page 13); SANITIZING PROCEDURE



a. Coat inside of agitators (if present) with
Spaceman lubricant and install with arrow
poinng up.
b. Install internal and front drip trays.
c. If machine will be le unused, install air
tubes and place hopper lids on top;
otherwise, set air tubes aside unl aer
machine has been primed.

 
Aer sanizing the machine, DO NOT rinse or touch areas that have been sanized.
Product must be added immediately. If new product will not be added immediately, rinse machine
with clean water and loosen door hand-screws to allow cylinders to air-dry. Sanize machine before
using again.
1. Verify assembly is complete.
2. If installed, remove hopper covers and air
tubes.
3. Verify draw valves are in the CLOSED
posion (UP).
4. Mix a minimum of 8 liters (2.11 gallons) of
food-grade sanizer in a bucket or
container.
5. Pour half the food-grade sanizer soluon
into each hopper.
6. Turn power switches ON.
7. Press RESET buon; press WASH buon to
begin cycle. Allow soluon to agitate for 5
to 10 minutes; NEVER leave machine on
WASH for more than 10 minutes.
8. While agitang, gently use a clean brush to
scrub and distribute sanizer soluon along
hopper walls.
9. Place a bucket or container below the draw
valves; OPEN the draw valves (DOWN) and
drain soluon from the machine.
10. Press RESET buons to stop cycle.
 



Always use food-grade, no-rinse sanizer to sanize. If warm water is required to dissolve
sanizer, allow the soluon me to cool before adding to machine.




 



