Spaceman 6350 - MACHINE OPERATION: FREEZE (Page 16); DISPENSE PRODUCT; MACHINE POWER RESET

Side draw handles dispense product from their respecve hoppers. The
middle draw handle twists product from the le and right hoppers.
1. OPEN draw valve (Handle Down) unl desired amount is dispensed
2. CLOSE draw valve (Handle UP) when nished dispensing
Adjustment screws below draw handles control dispensing speed.
• Tighter (clockwise) reduces speed
• Looser (counter-clockwise) increases speed


If machine doesn’t turn on, turn power OFF, repeat steps 1 to 5. If problem persists, contact
service team.
If machine makes any abnormal noise during reset, immediately switch power OFF and
contact service team.
-(usually because
the viscosity is set too high for the selected product) to prevent motor damage. Use the 
funcon to return the machine to normal operaon.
1. Switch power switches OFF.
2. Press power reset buon underneath front overhead, (If you can not nd power reset
buon, please disassemble the machine panel and press Reset buon on Inverter).
3. Press and hold STANDBY buon for 3 seconds and turn on Defrost mode.
4. Press RESET on Control Panel and re-prime. Li up prime plug and make sure product
comes out from boom prime port. Close prime plug.
5. Press RESET then WASH buon. Once product comes out of two small holes on pump
cover, press RESET to complete priming.
6. Observe machine performance and return to normal use if funconing properly.




Turn on freezing immediately to cool product down to serving consistency.
Use when quick serve is required aer long idle period.

• Under FREEZE mode press ICE CREAM buon

If adjustment screw is ghtened too far, product may not
dispense. If this occurs, loosen adjustment screw unl product dispenses.
 
Overrun is the amount of air mixed in with the product.
The higher the overrun, the higher the amount of air in each serving.
1. Turn sucon tube lever to the LEFT to reduce overrun;
Turn sucon tube lever to the RIGHT to increase overrun.
2. Six overrun levels total. Recommend to use 2-5.
3. Overrun and texture change will be visible aer 6-8 dispenses.
1
2
3 4 5
6



CAUTION: Overrun seng can dier between products. Seng too high of overrun can cause the
machine to malfuncon. When increasing overrun, you may need to reduce the viscosity seng.