1. Inadequate mix in hopper.
2. Warm product added to hopper.
3. Hopper temperature seng is too low.
1. Ensure hopper is at least half full.
2. Pre-chill product before adding to hopper.
3. Adjust hopper temperature warmer (Page 16).
1. Improper or inadequate lubricaon of drive
sha seal.
2. Damaged, missing, or improperly installed drive
sha seal.
1. Use sucient food-grade lubricant, and add
sucient lubricant inside drive sha gasket
during assembly (Page 9).
2. Replace drive sha gaskets every 1 to 3 months.
1. Improper or inadequate lubricaon of draw
valve and draw valve O-rings.
2. Cracked, broken, or worn draw valve O-rings.
1. Use sucient food-grade lubricant when
assembling draw valves (Page 10).
2. Replace O-rings every 1 to 3 months.
1. Machine isn’t cleaned/lubricated adequately.
2. Inadequate mix in hopper.
3. Product breakdown
4. Improper mixing of product.
5. Machine doesn’t have adequate venlaon.
6. Viscosity adjustment is set incorrectly.
1. Clean and properly lubricate machine daily.
2. Ensure hopper is at least half full.
3. Recycle fresh product.
4. Follow manufacturer instrucons for mixing
product; ensure correct mix raos.
5. Ensure at least 152mm (6'') clearance on all
sides.
6. Raise viscosity seng as required (Page 16)
1. Warm product was recently added.
2. Hopper temperature seng is too high.
3. Temperature osets need adjustment.
1. Allow at least 1 hour aer adding new mix for
hopper temperatures to stabilize.
2. Adjust hopper temperature warmer (Page 16).
3. Call Spaceman Technical Support.
Cylinders are experiencing freeze-up.
1. Check mix level.
2. Check for starved cylinder (refer to Stop 1 and
Stop 2 troubleshoong on page 21)
3. Reset machine (Page 14), and lower viscosity as
required (Page 16).
1. Improper assembly.
2. Wearable parts need replacement.
3. Internal cleaning/maintenance required.
4. Damaged internal parts.
1. Stop machine use, drain product with machine
powered OFF; clean and inspect parts.
2. Replace wearable parts (including scraper
blades) at least once every 3 months.
3. Inspect parts carefully for damage, ensure
proper assembly; replace as required.
4. Contact Spaceman Technical Support.
To Previous Page
Loading...
