8999151EN: v1 11/03/2021
20
Original instructions (ENGLISH)
Website: www.spearheadmachinery.com
The tractor should exceed the weight of the machine by at least 20%. For machine weights see
Section 1.5.
IMPORTANT: Before preceding to start work ensure that steering and braking give proper
operation and are in good condition.
CAUTION! Before proceeding to take the machine into the work area ensure that driving vision
is not impaired by tractor, cab or implement for clear vision of ground hazards and bystanders
while seated in the driver’s seat.
Adjust rear view mirrors in order to see clearly the machine and all items behind.
CAUTION! Where a machine is used in conjunction with tractors not fitted with a glazed safety
cab, a clear polycarbonate safety screen together with a mesh guard must be fitted to the tractor
between the operator and the cutting unit. A polycarbonate safety screen must be used on
cabs where windows are likely to be left open for ventilation purposes. It is essential that cab
windows on the operating side, through which the machine is observed, are intact, clean and
closed. Otherwise a clear polycarbonate safety screen must be fitted where grass trimming
operations are carried out.
CAUTION! Always wears protective, steel toe-cap boots when operating or being anywhere
near the tractor or machine.
CAUTION! If the agricultural tractor has no closed cabin, the operator is required to use extra
Personal Protection Equipment. Ear protectors are required and a dust mask if the working
ground lifts a considerable amount of dust along with safety glasses. If your health is
compromised during work or afterwards, stop immediately and seek professional medical
advice immediately.
CAUTION! If the agricultural tractor has no closed cabin, the tractor must be equipped. The
“Rollover Protection Structure” (ROPS) must always be locked in position.
CAUTION! Ensure that the tractor destined to be used with the machine has a vertical
escaping, bonnet mounted exhaust to reduce potential fire risk when the machine is in
operation. If the tractor is equipped with a under frame exhaust seek a different tractor of use.
CAUTION! If two or more tractors/machines are being used in close proximity in the working
area, enclosed cabs must be used.
IMPORTANT: The condition of blades and all guards must be checked before beginning daily
work and they must be replaced if damaged or missing before proceeding to use the machine.
IMPORTANT: Periodically (every 8 hours) verify that the screws and bolts are tightened and
secure, especially those that secure the blades.
IMPORTANT: The condition of the headstock wire ropes must be checked before beginning
daily work and they must be replaced if damaged or missing before proceeding to use the
machine.
IMPORTANT: Using the types of lubricating oils indicated by Spearhead and follow the
recommended guidelines of the lubricant manufacturer. Check oil levels and grease points daily
to ensure the longevity of your components on your machine following the maintenance section
of this operators manual.
Follow the guidance of the lubricant manufacturer with regards to handling oils, solvents,
cleansers and other chemical agents.
CAUTION! Check the machine daily for gearbox leaks. If any component in the system is
faulty, replace the component before preceding to use the machine.