Spearhead Multicut 300 - Environmental Considerations; Machine Disposal Guidelines

8999151EN: v1 11/03/2021
32
Original instructions (ENGLISH)
Website: www.spearheadmachinery.com
2.9 The Machine & The Environment
Below are the minimum provisions to be followed in order to reduce the risk of environmental impact connected
to the use of the machine:
• If the Country where the machine is used foresees specific sound emission limits, it is best to adapt to
the provisions in these standards, if necessary, being supplied with suitable protective equipment
(earplugs, muffs, etc.).
• It is mandatory to respect current legislation of the Country where the machine is used, related to use
and disposal of lubricants and products used for machine cleaning and maintenance, observing the
recommendations of the manufacturer of those products.
• If replacing worn parts or during demolition, one must follow anti-pollution laws foreseen in the country
where the machine is used.
• It is prohibited to pour products used for cleaning or polluting substances into the sewerage drain, on
the ground, in watercourses, or into the environment.
• It is mandatory to collect products used for cleaning and polluting substances in appropriate
containers, store them and deliver them to companies authorised for their disposal.
2.9.1 Disposal
When Spearhead equipment reaches the end of its economic working life it should be disposed of responsibly,
either through an approved recycling centre or by compliance with all regulations in force in the destination
territory.
In most instances Spearhead machines can be broken into its constituent parts with the use of basic workshop
equipment. Table contains a typical list of constituent materials, together with disposal guidelines.
When undertaking a machine breakdown, take care to ensure that heavy parts are always adequately supported
to avoid injury.
To avoid environmental contamination, take containment precautions to retain control of liquids in order.
It is the owner’s responsibility to ensure the machine is disposed of in accordance with all applicable regulations.
Material
Typically found in;
Disposal guideline
Steel
Structural components, fixed guards,
fasteners and driveline
Can be dismantled and recycled. Take care
when handling heavy and/or sharp objects
Aluminium
Pump and gearbox housings, serial
number plates
Can be dismantled and recycled. Take care
when handling heavy and/or sharp objects.
Take appropriate actions for oil contaminated
products
Copper
Wiring, electrical components
Can be recycled using appropriate recovery
procedures.
Hydraulic oil
Tank, hydraulic components
Dispose of in accordance with all applicable
regulations
Rubber
Hoses, flexible guards, seals, ‘O’ rings
Dispose of in accordance with all applicable
regulations
Plastics
Clips, caps, cable ties, decals, filter
housings, document holders, bushes,
electrical components, plugs, connectors,
wire insulation
Dispose of in accordance with all applicable
regulations
Filter element
Filter housings
Dispose of in accordance with all applicable
regulations
Cork / paper
Gaskets
Dispose of in accordance with all applicable
regulations
Table 2.5 – Machine Breakdown Component Disposal