Spearhead Multicut 300 - Fitting the PTO Shaft

8999151EN: v1 11/03/2021
38
Original instructions (ENGLISH)
Website: www.spearheadmachinery.com
Figure 3.8
Check the length of the driveshaft at the minimum
position to ensure the shaft will not bottom. See
Figure 3.2 for guidance.
If further adjustment is required; repeat the process.
3.3.4 Fitting The PTO Shaft
For guidance on fitting the Power Take Off (PTO) shaft between the machine and tractor; see Section 4.4.