Spearhead Multicut 300 - Machine Components; General Arrangement

8999151EN: v1 11/03/2021
9
Original instructions (ENGLISH)
Website: www.spearheadmachinery.com
1.2 General Arrangement
The layout and naming convention used throughout this manual for each of the machines are shown in the table
below. The numbering and positioning of the relevant item can be found for the particular machine in Section
1.2.1.
Item No.
Description
1
Deck
2
Wheel Arm & Yoke Assembly
3
Splitter Gearbox
4
Rotor Gearbox
5
Flexible Coupling*
6
PTO (Power Take-off) With Overrun
7
Height Adjuster Pin
8
Driveline Guard
9
Headstock
10
Wire Rope
11
Blade
12
Anti-scalp Dish*
13
Skid
14
Chain Guard
15
Guide Wheels
Table 1.1 – Multicut 300 Machine Components
* Multicut 300 machines can be specified in a variety of specifications when purchased brand new. Figure 1.2
shows an example Multicut 300 specification. It is important to state the actual supplied machine may vary to the
layout and specification as shown in Figure 1.2.
A full list of Multicut 300 specification options can be found in Section 1.5.2.