11
installed driver does not work, you may replace it with one
of the two drivers posted on the Spectra Precision website:
http://www.spectraprecision.com/eng/sp90m.html#.WUkG_NxLep0
USB driver for 64-bit OS: SpectraPrecisionUSBSerialSetup_x64.exe file
USB driver for 32-bit OS: SpectraPrecisionUSBSerialSetup_x86.exe file
Double-click on the downloaded file to install the driver.
• [7]: Escape button. See Using the Front Panel Controls on
page 26.
• [8]: Bumpers (x2).
Rear Panel
• [8]: Bumpers (x2).
• [9]: GNSS input #1. A TNC coaxial female connector
allowing you to connect the first GNSS antenna to the
receiver via a coaxial cable.
• [10]: GNSS input #2. A TNC coaxial female connector
allowing you to connect the second GNSS antenna to the
receiver via a coaxial cable.
• [11]: External GSM antenna (optional). A coaxial female
connector (SMA type) allowing you to connect an external
cellular antenna.
The SP90m having a built-in GSM antenna, no external
GSM antenna is usually required. In case of adverse
reception conditions however (e.g. SP90m mounted in a
rack), an external antenna can advantageously be used for
better reception. Run the Web Server (Receiver> Network>
Modem> Modem Antenna) to choose which of the internal or
external antenna should be used.
The SP90m uses a GSM antenna when it sends or receives
RTK or differential corrections via its GSM modem.
• [12]: UHF radio connector. A TNC coaxial female
connector allowing you to connect a radio whip antenna.
This connector is available only if the SP90m has been
fitted with an internal radio.
[9]
[13]
[17][16][14] [15]
[10] [11] [12]
[8] [8]
To Next Page
Loading...
