45
Using a USB Key
To Copy Files Whenever you connect a USB key to the receiver via cable
P/N107535, the following screen is displayed:
This screen is displayed for a few seconds. If you press OK
while this screen is still displayed, all the G-files and log files
stored in the receiver will be copied to the root folder on the
USB key (or will overwrite the files with same name).
Otherwise the copy operation will be skipped and the receiver
will come back to the General Status screen. The screen looks
like this while the files are being copied.
The same will happen if you power on the receiver with a USB
key already connected to the receiver.
To Upgrade the
Firmware
When a new firmware upgrade is available, it is easy to install
the new firmware using a USB key.
• Use your computer to copy the installation file (a *.tar file)
to the root directory of the USB key.
• The receiver being turned off, connect the USB key to the
receiver through cable P/N 107535 (provided).
• Press the OK button and the Power button simultaneously
for a few seconds. This starts the upgrade.
195
To Next Page
Loading...
