59
RTK or DGPS Rover
On the receiver’s General Status screen, the receiver will
display “FIXED” (with short “FLOAT” transition time) or
“DGPS” when computing a position respectively in RTK or
DGPS mode. The computed position is displayed after
pressing .
When corrections are received and used, is displayed on
the General Status screen together with the age of corrections
(see General Status on page 27).
To configure the receiver as a DGPS or RTK rover, use the Web
Server as follows:
• Go to Receiver > Position > Rover Setup.
• Set Processing Mode to RTK.
• Specify how the corrections are forwarded to the receiver
by setting Input Mode accordingly. If you choose Automatic,
the receiver will find by itself which of its ports is used to
acquire corrections. If you choose Manual, you need to
specify this port.
• Additionally, in the Other Settings section, you may change
the primary GNSS system used (GPS is the default
selection), limit the level of position accuracy to less than
what the receiver can actually achieve in this case.
Typically you will choose RTK Position or (RTCM) Differential
Position to match with the selected operating mode
(respectively RTK or DGPS).
• Select the model of dynamics that suits the movement
pattern of your rover best.
• Click Configure.
• Set the device used by the receiver to acquire corrections:
– If corrections are received via radio, go to Receiver >
Radio to enter all radio parameters. You may use the
internal radio or an external radio.
1
XYZ or
Lat-Lon-Height
Position
One set of corrections via:
• Internet (Ethernet, cellular modem, or WiFi), or
• UHF Radio
To Next Page
Loading...
