Spectra Precision SP90m - Precise Positioning Performance

95
ANH: Setting
Antenna Height
Send this SMS to change the receiver antenna height. You
can either send a vertical or slant measurement (both in
meters) of the antenna height.
Command Syntax:
ANH<sp>VERT<sp>{vertical measurement}
or
ANH<sp>SLANT<sp>{slant measurement}
Example 1: Sending vertical height measurement
ANH VERT 2.124
SP90m 5703A00116
11:02:14
ANH VERT 2.124 m: OK
Example 2: Sending slant height measurement:
ANH SLANT 1.645
SP90m 5703A00116
11:02:14
ANH SLANT 1.645 m: OK
ANR: Setting
Antenna Reduction
Mode
Send this SMS to change the location for which the receiver
computes a position.
Command Syntax:
1) Position computed for antenna L1 phase center location:
ANR<sp>OFF
or
ANR<sp>PC1
2) Position computed for ground mark location:
ANR<sp>ON
or
ANR<sp>SPT
3) Position computed for antenna reference point (ARP):
ANR<sp>ARP
Example:
ANR ON
SP90m 5703A00116
11:03:40
ANR ON: OK