Spectra Precision SP90m - Static or Moving Base; Using the Web Server

68
aware the position computed in Relative RTK, in terms of
accuracy, is an SBAS Differential position at best.
• Select the model of dynamics that suits the movement
pattern of your rover best.
• Click Configure.
• Set the device used by the receiver to acquire the two sets
of corrections:
– If corrections are received via radio, go to Receiver >
Radio to enter all the radio parameters. You may use
the internal radio or an external radio.
– If corrections are received over the Internet, go to
Receiver > Network to set the device used (this may be
Ethernet, Modem or WiFi; more information about how
to set up theses devices can be found in the relevant
context-sensitive Help). Then go to Receiver > I/Os to
start data reception in NTRIP or Direct IP mode.
Static or Moving
Base
Using the Web Server
To configure the receiver as a base, use the Web Server as
follows:
• Go to Receiver > Position > Base Setup.
•Use the Station ID. field to enter the identification number.
Remember, the station ID should comply with the type of
correction data format the base generates. As a reminder,
this is the list of authorized numbers in relation to the data
format used:
– RTCM 2.3: 0-1023
– CMR/CMR+: 0-31
– ATOM & RTCM3.x: 0-4095
• Indicate whether the base is stationary (Static) or in motion
(Moving).
If you choose Static, you need to specify the exact location
of the base. You can do this in two different ways:
1
Base corrections delivered via:
• Internet (Ethernet, cellular modem, or WiFi), or
• UHF Radio