49
• Then you should indicate how the WiFi device will be
power-controlled and whether it will operate as a WiFi
client, as WiFi access point or both. Follow the steps
below:
– The previous screen being still displayed, press OK.
– Select Settings:
–Press OK again.
– Choose a power mode for the WiFi device: press OK,
select either Manual or Automatic (see explanations on
page 34 before making a choice) and then press OK.
– Press any of the vertical keys and then press OK.
– Choose an operating mode for the WiFi device: select
either Client, Access Point or AP and Client, depending on
the use case (see the next three sections below) and
then press OK.
– On your laptop or smart phone, start searching for WiFi
devices. When your SP90m receiver has been found,
select it and then enter the WiFi key (by default the
receiver serial number) to allow a WiFi connection with
the receiver.
– Back on receiver side, press to go back to the WiFi
“root” screen. If you have selected Access Point or AP
and Client, you will be able to read the IP address of the
WiFi access point in the lower line. Type in this IP
address (fixed, static address: 192.168.130.1) in your
computer or smart phone’s web browser to launch the
receiver’s Web Server.
When a WiFi connection is active, one or two of the
following icons appear on the General Status screen:
The first one indicates that the WiFi device is used as
an access point and the second one as a client.
To Next Page
Loading...
