Spectra T950 - Page 12

Prepare for the Replacement Prepare the Left Frame
March 2015 HAX Motor Replacement—Spectra T950 Library
12
Remove the Fan Assembly and HAX Motor Bay Cover
(Bulk TAP Frame Only)
1. Usea#2Phillipsscrewdrivertoloosenthefourcaptivescrewssecuring
thefanassemblytothefrontoftheframe.
Note: Itisnotnecessarytoremovethefilterfromthefanassembly.
2. Graspthelower‐middleoftherightandleftsidesofthefanassembly
andcarefullypullitstraightoutoftheframe.
3. Usinga#2Phillipsscrewdriver,removethefourscrewssecuringthe
HAXmotorbaycovertothefrontoftheframe.Setthecoverandscrews
aside.
4. ContinuewithRemovetheHAXMotoronpage 15.
Figure 12 Loosen the captive screws securing the fan assembly to the frame.
Captive
screws (4)
Front of frame
Figure 13 Remove the HAX motor bay cover.
Screws (4)
HAX motor
bay cover