Spectrum DX6R - Timer Operation Details

30
TIMERS
Timers 1-3 can be configured to be either an Up, Down or Lap Timer.
Up Timer-
The Up Timer counts up, functioning as a stopwatch
when triggered via a selectable button/switch. It
is useful for timing a fuel run to determine fuel
mileage/pit stop strategy or, for electrics, to time the
run time of a pack to determine gear ratio and setup
information.
• Select minutes (0-599) and seconds (0-59) by
tapping in the appropriate box.
• Select the button or switch to activate, pause and
reset the timer.
• This timer can also be paused or reset on the
main DashBoard screen.
Down Timer-
The down Timer counts down, when triggered via
a selectable button/switch. When the down timer
expires, an Alert will sounds and the timer begins to
count up.
• Select minutes (0-599) and seconds (0-59) by
tapping in the appropriate box.
• Select the button or switch to activate, pause and
reset the timer.
• This timer can also be paused or reset on the
main DashBoard screen.
Rolling Lap Timer-
Start the Rolling Lap Timer via a selectable
programmable switch. When the timer expires, an
alarm sounds and the Lap timer resets and begins
to count down again.
• Select minutes (0-599) and seconds (0-59) by
tapping in the appropriate box.
• Select the button or switch to activate, pause and
reset the timer.
• This timer can also be paused or reset on the
main DashBoard screen.
IMPORTANT: Configure the Timers Alert type (Tone, Vibrate, Tone + Vibrate or
Voice), by going to the ALERTS screen in SETUP.